DeMuth, Steel Products
Open Site Navigation

Center Fill Gooseneck Pipes

Ring Drive Center-Fill Gooseneck

Ring Drive Center-Fill Gooseneck

SURESHOT ADJUSTABLE GOOSENECK BASE – Designed for use with the Lancaster Ring Drive Center-Fill Goosenecks only for use with center discharge unloaders. Allows user to adjust the flow of silage – while standing on the platform – to fall directly in the center of the silo. An 18” long downspout is included.

(for use with 540 RP’ Forage blowers only)

Conventional Center-Fill Gooseneck

Conventional Center-Fill Gooseneck

  • Durable, rigid galvanized box frame construction on lower section. Upper section opens on bottom, but firmly supported with extra bracing.

  • Quick and easy to install, including mounting brackets, attaches to first two silo hoops.

  • Factory preassembled for quality assurance.

  • Heavy stainless steel liner turns the stream of feed and handles the initial impact.

  • Lower profile gooseneck available for 10’ thru 14’ silos in 9” or 12” models. 12” width is recommended for haylage.

  • Expect many years of service If replacement is needed, replace the damaged section only.

  • Center fill goosenecks discharge at the center of the silo and are used with ring drive unloaders.

(for use with 540 RP’ Forage blowers only)

Center-Fill Gooseneck

Center-Fill Gooseneck

  • Durable, galvanized rigid box frame construction.

  • Quick & easy to install.

  • Factory preassembled for quality assurance.

  • Heavy stainless steel liner turns the stream of feed and handles the initial impact.

  • 9" or 12" models. (12" width is recommended for haylage and greater blowing capacity.)

  • Expect many years of service If replacement is needed, replace the damaged section only.

  • The Lancaster Harvestore and Multiple Goosenecks are a High-Profile design that have a smoother arc to reduce friction. The end section is vertical and more accurately places fed where you want it.

  • Note: Goosenecks are available for most conical roof silos.

HEAVY DUTY GOOSENECKS available and should be used in the following conditions:

(for Glass-Lined and Concrete bottom unloading silos)

  • For high moisture grains

  • For any feed with high horsepower on the blower (150 or more)

Conception

|

​© 2021 DeMuth Steel Products Inc - All rights reserved